![]() If you can / are allowed to by ISP, buy a different modem/router that DOES support NAT loopback out of the box. So each time the region doesn´t connect, you would manually need to verify this before starting it. Use static IP adresses! If you are running DHCP (dynamic IP addresses) you don't know if the port forwarding is failing, or the public IP has changed. (and troubleshooting these are not for the faint at heart). So depending on if you run a DNS name or IP-address, you will need to configure and enable LMhost or Netbios lookups on your network adapter.Īgain, mind all of the above are workarounds, not Fixes ! Also they make your network function different than normal, which can lead to unexpected results in certain scenario’s. Only NetBIOS-legal names are allowed in this file. The "LMHOSTS" file contains entries that simulate NetBIOS name resolution responses. Only DNS-legal names are allowed in this file. The "HOSTS" file contains entries that simulate "A" records in DNS (and PTR records, too). Possibly you can get around that as well, by making an entry in that systems (Hidden) LMhosts file, pointing your public IP tot he local LAN IP of the simulator. (which doesn’t support the NAT loopback, remember…). All other machines in the LAN have no other means than connecting to the simulator through your router. The loopback only works for the machine it is installed on. ![]() What does not work in this scenario, is traffic from your local network towards this machine. Incoming traffic from the internet should work as well. (you get around the issue, but some things will just fail, and keep failing in this scenario).Ībove should enable you to connect a viewer that resides on the same pc as the simulator. They make things work, but it are not FIXXES. If your public IP changes, you need to set it here again. In which your Interface name is the name of the connection (Microsoft KM-TEST Loopback Adapter atm probably, mind you can rename it by right clicking it) and your Public_Ip is the address you got from. netsh interface ipv4 set address name=Interface_Name source=static addr=Public_IP mask=255.255.255.0.Even if you run a static LAN IP (preferred), with this setup it is required to configure region.ini with a local IP of 0.0.0.0 else it might still fail.įrom a commandline it would look something like : close the error with x and hit ok to apply the settings. When you hit ok, it gives an error about missing subnet, and fills one by itself. 3.On the General tab, click Use the following IP address, and then type the IP address without subnet mask / gateway / DNS (so just the IP, like 64.31.16.122 ).2.Click Internet Protocol (TCP/IP), and then click Properties. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |